Saving Stations Manually; Calling Up The Stored Station; Receiving Stations In Mono - Silvercrest SCUR 3 A1 Instrucciones De Uso E Indicaciones De Seguridad

onds to set the volume with the −VOL+/ І◄◄ TUNE ►►І dial

Saving stations manually

♦ Use the −VOL+/ І◄◄ TUNE ►►І dial
♦ Press the CLOCK/MEMORY button
gramme space (e.g. P01) flash on the display
♦ Turn the −VOL+/ І◄◄ TUNE ►►І dial
desired programme space (P01 to P20).
♦ Press the CLOCK/MEMORY button
desired programme space.
♦ Repeat these steps to save up to 20 stations. The same station can be saved
in more than one programme space.

Calling up the stored station

To call up a stored station, press the CLOCK/MEMORY button
♦
radio mode and then turn the −VOL+/ І◄◄ TUNE ►►І dial
or left to select a station.
♦ Alternatively, press the CLOCK/MEMORY button
radio mode until the desired station is shown.

Receiving stations in mono

It is sometimes possible to improve the playback quality of stations with a poor or
unstable signal strength by switching from stereo to mono playback.
♦ Use the ■ ST/MONO button
back. If stereo playback is activated, "((ST.))" appears on the display
when a stereo radio station is received.
NOTE
► To improve FM reception quality, you can also try repositioning the wire
aerial
SCUR 3 A1
and/or the device.
to set the desired station.
until
"MEMORY" and the pro-
.
to the left or right to select the
again to save the station in the
several times while in
to switch between mono and stereo play-
again.
while in
to the right
GB │ IE
43 ■
│