Charging Battery - Baxtran RTN Manual De Usuario

RTN
Price-computing scale

CHARgINg BAttERy

> To charge the battery insert the adaptor pin to jack, jack is locating below the scale. Adaptor simply plug
into the mains power. The scale no needs to be turned on.
> The battery should be charged for 12 hours for full capacity.
> Left side of the display there is an LED to indicate the status of battery charging. When the scale is plug-
ged into the mains power the internal battery will be recharged. If the LED is green, the battery has a full
charge. If it is red, the battery is nearly discharged and if yellow, the battery is being charged.
> Do not use any other type of power adaptor than the one supplied with the scale.
> Verify that the AC power socket outlet is properly protected.
Note: Please charge the battery before using the scale for the first time.
INStALLAtION
> Place the scale on a table.
> Carefully place the pan to the four holes on the top cover
> Adjust the water mark bubble level.
> Connect the adaptor pin to the adaptor jack. Adaptor jack is locating below the right side of the scale.
> Adaptor connects into your AC power socket. Pluggable equipment must be installed near an easily acces-
sible socket outlet with a protective ground/ earth contact.
> Turn on the power switch. On / Off switch is locating below the right side of the scale. Press switch forward
to turn on the scale. If you want to turn off, press again the switch backward.
> Display will be show the scale capacity and will be starting self checking.
> After self checking, display will be come to normal weighing mode.
> Then you can start your operation
Note: initial Start Up
Warm-up time of 15 minutes stabilizes the measured values after switching on.
SCALE dESCRIPtION
User's guide
All manuals and user guides at all-guides.com
5. SCALE, KEyPAd ANd dISPLAy dESCRIPtION
1. ON/OFF switch
2. Adaptor Jack
3. Adjusting feet.
1
2
3
4
5
4. Display bracket
5. Function/CAL Switch
6. RS232 output
ENG FR ES
6
43