To Install Or Replace Battery; To Start Weighing; To Convert Weight Units; Zero' Or 'Tare' Function - Baxtran GLASSKS Manual Del Usuario

USER MANUAL - EN

1. TO INSTALL OR REPLACE BATTERY

2x1.5V (AA/AAA) batteries (excluded). Remove package foil before use;
A. Take out used batteries, with the aid of a sharp object if needed.
B. Install new batteries by putting one side of the battery down first
and pressing down the other side. (Please observe the polarity)

2. TO START WEIGHING

A. Place the scale on a solid and flat surface.
B. Place bowl (is used) on the scale before turning on the scale.
C. Press to turn on the scale
D. Wait until the LED shows "0" to start weighing.
E. Load weighing object on to start weighing. LED will show the
weight reading.
4
USER MANUAL GLASSKS

3. TO CONVERT WEIGHT UNITS

The unit system of scale depends on
sales destination or the requirement of distributor.
4. "ZERO" OR "TARE" FUNCTION
The weigh different loads consecutively without removing loads
from the scale. Put first load on the scale, fet weight reading. Press
button to reset the LED reading to "0" before adding next load. You
can repeat this operation.
• Condition 1: "ZERO" function when total sum of all loads on
scale ≤ 4% of scale's max capacity is 2kg; 200g when capacity
is 5kg)
LED will show "-----" or "0g" each time
means not stable, please wait for a moment. Indicating "ZERO"
funciton is active. Max. capacity ramains unchanged.
If the scales is with both
measuring system of Metric
(kilograms, grams) and Impreial
(pounds, ounces), you can
press to convert between two
systems during the course of
weighing. (The unit conversion
button is at the bottom of scale,
as shown in the left picture.)
Remark:
is pressed. "----"
EN