Medtronic MMT-7306 Guia Del Usuario página 7

MP6025822-22C1 / A
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by increasing the separation
between the equipment and receiver.
In the unlikely event that communications does not resume by switching to other channels,
communication problems can typically be resolved by ensuring that the distance between
transmitter and receiving device is less than 1.8 meters (6 feet), and by turning off or moving
away from other RF transmitting devices. You can also reorient or relocate the CareLink USB and/
or the transmitting device to try to correct the interference. Note that RF interference will not
cause any incorrect data to be processed and will not cause any harm to your CareLink USB. If you
continue to experience RF interference, please contact your local representative.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
5