Setup And Use - Biamp Vocia WS-4 Manual Del Operador

WS-4 / WS-10 and EWS-4 / EWS-10 Setup and Installation

Setup and Use

The Vocia software provides an intuitive interface for configuration, DSP equalization and programming of
the WS-4 and WS-10 components. The information supplied by this manual relates to physical
connections and assignment. For more details on software setup, please consult the Vocia Help File.
NOTE
Vocia software can configure the WS-4 or WS-10 for dedicated use as na Emergency Paging Station. When so configured, the
WS-4 or WS-10 is referred to as an EWS-4 or EWS-10.
Vocia Installations designed to comply with the requirement of EN54-16 must be installed in accordance with Biamp
recommendations detailed in this Use Manual and in the Vocia VACIE Guide (download form www.biamp.com )
Installation
Install the unit away from heat sources, such as vents and radiators, and in rooms with adequate
ventilation. Ensure that air can circulate freely behind, beside, and above the unit. Do not exceed the
maximum ambient operating temperature of 32°-113° F (0° -42°C). Be aware of conditions in an enclosed
rack that may cause the temperature to exceed ambient room conditions.
Installation
Any combination of the screw holes shown in the rear view diagram can be used to mount the bracket to
the wall (do not fit a screw to the hole marked no screw). A minimum of four screws should be used.
Please note: the maximum screw head height is 0.157 inches (4mm) (dimension from top of installed
screw head to inside of mounting bracket). Screws with larger heads may damage the unit.
The paging station must be cabled and its Device ID set before mounting it to the bracket. Please use the
four M3 x 8mm countersunk screws supplied to secure the paging station to the bracket.
The following diagrams have been provided for guidance in installing this product.