Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION – RISK OF SHOCK – Disconnect Power at the main
circuit breaker panel or main fuse box before starting and during
the installation.
Before Installing:
All installations should comply with National and
local electrical codes. If you have any doubts concerning
installation, contact a qualified licensed electrician.
1)
Find the appropriate threaded holes on mounting strap.
Assemble mounting screws into threaded holes.
2)
Attach mounting strap to outlet box. (Screws not provided).
Mounting strap can be adjusted to suit position of fixture.
3)
Grounding instructions: (See Illus. A or B).
A)
On fixtures where mounting strap is provided with a
hole and two raised dimples. Wrap ground wire from
outlet box around green ground screw, and thread into
hole.
B)
On fixtures where a cupped washer is provided. Attach
ground wire from outlet box under cupped washer and
green ground screw, and thread into mounting strap.
If fixture is provided with ground wire. Connect fixture
ground wire to outlet box ground wire with wire connector.
(Not provided.) After following the above steps. Never
connect ground wire to black or white power supply wires.
A
WIRE CONNECTOR
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
GREEN GROUND
SCREW
Date Issued: 07/28/17
B
FIXTURE
GROUND
OUTLET BOX
GROUND
CUPPED
GREEN GROUND
WASHER
SCREW
We're here to help
OUTLET BOX
BOÎTE À PRISES
4)
Make wire connections (connectors not provided.) Reference
chart below for correct connections and wire accordingly.
Connect Black or
Red Supply Wire to:
Black
*Parallel cord (round & smooth)
Clear, Brown, Gold or Black
without tracer
Insulated wire (other than green)
with copper conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
5)
Push fixture to ceiling, carefully passing mounting screws
through holes in canopy.
6)
Thread knurl knobs onto ends of mounting screws. Tighten
knurl knobs to secure fixture to ceiling.
7)
Insert recommended bulbs.
8)
Raise the glass up through trim into fixture, passing over the
socket.
9)
Turn glass to secure glass in place. (DO NOT over tighten)
10) Raise the lower trim over the glass and align the holes to pass
over the studs. Rest lower trim against the upper trim.
11) Slip a washer onto the stud, followed by threading on a finial.
Repeat for remaining studs. Tighten all finials to secure the
trim.
866-558-5706
Hrs: M-F 9am to 5pm EST
WIRE
CONNECTORS
CONNECTEURS DE FIL
(2) STRAP MOUNTING SCREWS
VIS DE L'ÉTRIER DE MONTAGE
MOUNTING STRAP
ÉTRIER DE MONTAGE
(2) MOUNTING SCREWS
VIS DE MONTAGE
(2) LOCK-UP KNOBS
BOULES DE BLOCAGE
STUD
CLOU
GLASS
VERRE
LOWER TRIM
MOULURE INFÉRIEUR
WASHER
RONDELLE
FINIAL
ORNEMENT
Connect
White Supply Wire to:
White
*Parallel cord (square & ridged)
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with silver conductor
Neutral Wire
IS-49861-CB
Publicidad
