KNOVA KN M-2504RC Manual Del Usuario página 14

ASSEMBLY
6. Lower the guard assembly (4) onto riving knife (1).
Release the red spring button (5) so that two latches (7)
engage into two locking hooks (8) completely. (Fig. V, W)
7. Make sure that the assembly is locked in place both in
front and back. (Fig. W)
WARNING
To reduce the risk of serious injury, use
saw blade guard and riving knife for every operation
for which it can be used including all through sawing.
4
Removing the
blade guard and
anti-kickback
pawls
assembly
(Fig. T,W)
WARNING
To avoid injury
from an accidental start,
make sure the switch
is in the OFF position
and the plug is disconnected
from the power source outlet.
1. Raise the blade to the maximum
height position by turning the blade
elevation/tilting handwheel clockwise.
2. Loosen the blade bevel lock
knob and turn the handwheel
to 90° on the bevel scale.
3. Tighten the blade bevel lock knob.
4. Remove the anti-kickback pawls assembly by lifting the
anti-kickback pawls lever (2). (Fig. T)
5. Remove the blade guard assembly by pressing down the
red spring button (5) and lifting up the assembly. (Fig. W)
AVOIDING KICKBACKS (FIG. X)
To avoid kickback (having the work thrown violently back
toward you), keep the blade sharp, keep the rip fence parallel
to the saw blade and keep the riving knife, blade guard and
anti-kickback pawls in place, aligned and functioning. Do not
release the work before passing it completely beyond the saw
blade. Do not rip work that is twisted, warped or does not
have a straight edge to guide it along the fence. Do not
attempt to back out of a cut with the blade running.
Press down
5
5
8
1
6
5
WARNING
cause "kickback" and serious injury.
Anti-kickback Pawls
INSTALLING THE RIP FENCE (FIG. Y)
1. Lift upward on the rip fence handle (1) so that the
holding clamp (2) is fully extended.
2. Place the rip fence on the saw table and engage the
holding clamp (2) to the table rear rail. Lower the front
end onto the front rail (3).
Fig. V
3. Push down the rip fence handle (1) to lock.
7
Fig. Y
Fig. W
WARNING
together.
13
Improper riving knife alignment can
2
3
Never use a rip fence and miter gauge
Fig. X
1