KNOVA KN M-2504RC Manual Del Usuario página 13

ASSEMBLY
INSTALLING THE RIVING KNIFE (FIG. Q, R, S)
WARNING
• To avoid injury from an accidental start,
make sure the switch is in the OFF position and the
plug is disconnected from the power source outlet.
• Never operate this saw without the riving knife in
the correct position.
1. Remove the table insert.
2. Raise the blade to the maximum height position by
turning the blade elevation/tilting handwheel (1)
clockwise. (Fig. Q)
3. Loosen the blade lock knob (2). Turn and move the
handwheel (1) to 45° on the bevel scale.
4. Tighten the blade lock knob (2).
5. Place the riving knife (3) on the mounting bracket (4)
located behind the saw blade. The two pins (5) on the
bracket should fit into the slot on the riving knife. (Fig. R)
6. Make sure the riving knife (3) is in its highest position.
7. Insert the set plate (6), making sure the two outer holes
fit into the two pins on the mounting bracket.
8. Insert the washer (7) into the lock lever (8) and insert into
the middle hole of the set plate (6) and tighten.
9. Loosen the blade lock knob (2) and return the blade to 0°
and lock.
10. Place the table insert back into position.
WARNING
• To avoid the lock lever interfering with
the table insert, after tighten the riving knife,
position the lock lever pointing downward before
using saw. Failure to maintain a level insert can
result in serious injury to the operator.
• The lever can be pulled
out to allow it to be turned
to a new position
downward. (Fig. S)
1
2
3
cavity side face
to lock lever
6
7
4
Fig. R
5
BLADE GUARD AND
ANTI-KICKBACK
PAWLS ASSEMBLY
(FIG. T, U, V, W)
WARNING
To avoid injury from
an accidental start, make
sure the switch is in the OFF
position and the plug is
disconnected from the power
source outlet.
• When installing
the blade guard,
cover the blade teeth
with a piece of folded
cardboard to protect
yourself from possible
injury.
Fig. Q
• Never operate this machine without the blade guard in
place for all through sawing operations.
Installing the blade guard and anti-kickback pawls
assembly (Fig. T, U, V, W)
1. Make sure the blade is elevated to its maximum height
and the bevel is set at 0°. Make sure the blade lock knob
is tight.
2. Raise the riving knife (1) to its highest position (through
cut position). Take the anti-kickback pawls assembly and
lift up the locking lever (2) located on top. (Fig. T)
3. Place the front of assembly
into slot (3) and
push down, making
sure the assembly is
engaged in the slots.
Push down on
the locking
lever (2) to lock.
(Fig. T, U)
NOTE: Make
sure the
anti-kickback pawls
assembly is locked
in position before
operating saw.
4. Take the blade
guard (4) and press
down on the red
spring button (5)
located on the top
of assembly. (Fig. V)
5. Position blade
guard over the
riving knife (1)
and align the
slot (6) to the
8
riving knife (1)
as shown in Fig. V.
12
8
Loosen
1
2
Tighten
3
6
Fig. S
2
3
Fig. T
Fig. U