To Disconnect The Cartridge From The Device - Prebena KT-1000 Manual De Instrucciones Original

To use the cartridge
 Unscrew the cap from the valve.
 Check the valve for debris and dirt.
 Clean the valve if necessary (see Page 12).
 Check the condition of the cartridge (see Page 9).
 Screw the cartridge finger-tight into the thread on the connecting
thread of the tool.
 Lubricate the connecting thread every time before using the tool.

To disconnect the cartridge from the device

After operation or after extended downtime periods, carry out the
steps described below:
 Unscrew the cartridge from the connecting thread.
 Pull the cartridge towards the back out of the holders for the
device.
 Screw the cap on the valve of the cartridge.
 Keep the cartridge protected against impacts and shocks in the
included transport case.
10
WARNING
There is a risk of an explosion if the maximum
operating pressure is exceeded (see operating
instructions for the tacker).
 If this case, immediately disconnect the
cartridge from the device.
WARNING
Operating the cartridge with unsuitable devices
can cause damage to the cartridge and the
devices.
 Only connect the cartridge to
manufacturer-approved devices.