Functional Description; Adjusting The Shoe - Makita JR3060T Manual De Instrucciones

Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.

Adjusting the shoe

1
► 1. Shoe 2. Shoe button
B
► 1. Shoe button 2. Shoe
When the blade loses its cutting efficiency in one place along
its cutting edge, reposition the shoe to utilize a sharp, unused
portion of its cutting edge. This will help to lengthen the life of
the blade. To reposition the shoe, push the shoe button in the
"A" direction with a click and reposition as shown in the figure
which allows you to make five-way adjustment. To secure the
shoe, push the shoe button in the "B" direction with a click.
Selecting the cutting action
► 1. Lever 2. Stopper
This tool can be operated with an orbital or a straight line cut-
ting action. The orbital cutting action thrusts the blade forward
on the cutting stroke and greatly increases cutting speed.
To change the cutting action, press the stopper and turn
the lever to the desired cutting action position. Then,
release the stopper to lock the lever. Refer to the table
A
to select the appropriate cutting action.
NOTE:
2
• Orbital action means that the saw blade moves
up and down, and back and forth at the same
time. This increases the efficiency of cutting.
Position
0
Straight line cutting action
I
Small orbit cutting action
Medium orbit cutting
II
action
Large orbit cutting
III
action
4 ENGLISH
1
1
Cutting action
For cutting mild steel, stainless
steel and plastics.
For clean cuts in wood and
plywood.
For cutting mild steel, aluminum
and hard wood.
For cutting wood and plywood.
For fast cutting in aluminum and
mild steel.
For fast cutting in wood and
plywood.
2
2
Applications