Makita JR3060T Manual De Instrucciones página 6

To install the saw blade, always make sure that the
blade clamp lever is in released position
insulation cover before inserting the saw blade. If the
blade clamp lever is in fixed position, rotate the blade
clamp lever in the direction of the arrow so that it can be
locked at the released positon
2
► 1. Blade clamp sleeve 2. Released position 3. Fixed
position
Insert the saw blade into the blade clamp as far as it will
go. The blade clamp lever rotates and the saw blade is
fixed. Make sure that the saw blade cannot be extracted
even though you try to pull it out.
► 1. Blade
NOTE:
• If you do not insert the saw blade deep enough,
the saw blade may be ejected unexpectedly
during operation. This can be extremely
dangerous.
If the lever is positioned inside the tool, switch on the
tool just a second to let the blade out as shown in the
figure.
Switch off and unplug the tool from the mains.
To remove the saw blade, rotate the blade clamp
lever in the direction of the arrow fully. The saw blade
is removed and the blade clamp lever is fixed at the
released position .
on the
.
1
3
1
► 1. Blade clamp lever
NOTE:
• Keep hands and fingers away from the lever
during the switching operation. Failure to do so
may cause personal injuries.
• If you remove the saw blade without rotating
the blade clamp lever fully, the lever may not be
locked in the released position
rotate the blade clamp lever fully again, then
make sure that the blade clamp lever locked at
the released position
OPERATION
CAUTION:
• Always press the shoe firmly against the work-
piece during operation. If the shoe is removed or
held away from the workpiece during operation,
strong vibration and/or twisting will be produced,
causing the blade to snap dangerously.
• Always wear gloves to protect your hands from
hot flying chips when cutting metal.
• Be sure to always wear suitable eye protection
which conforms with current national standards.
• Always use a suitable coolant (cutting oil) when
cutting metal. Failure to do so will cause prema-
ture blade wear.
Press the shoe firmly against the workpiece. Do not allow
the tool to bounce. Bring the blade into light contact with
the workpiece. First, make a pilot groove using a slower
speed. Then use a faster speed to continue cutting.
6 ENGLISH
1
. In this case,
.