Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Use a soft, dry cloth to wipe the area between the belt and deck.
2.
Spread lubricant onto the inside surface of belt and deck evenly (make sure the machine is turned off and power
is disconnected).
3.
Periodically lubricate the front and rear rollers to keep them at there peak performance.
If the treadmill belt/deck/roller is kept reasonably clean it is possible to expect over 1200 hours before additional
re-lubricating is necessary.
6 6 6 6 .4. .4. .4. .4. How
How
How
How to to to to check
1.
Disconnect the main power supply.
2.
Fold the treadmill up into the storage position.
3.
Feel the back surface of the running mat.
If the surface is slick when touched, then no further lubrication is needed.
If the surface is dry to the touch, apply a suitable silicone lubricant.
We
We
recommend
recommend
you
you
use
use
use a a a a silicone
We
We recommend
recommend you
you use
sports
sports
sports
sports Retailer
Retailer
Retailer or or or or a a a a local
Retailer
local
local
local hardware
6.5.
6.5.
6.5. Belt
6.5.
Belt
Belt Adjustment
Belt
Adjustment
Adjustment
Adjustment
Belt Tension Adjustment-It is very important for joggers and runners in order to provide a smooth, steady running
surface. Adjustment must be made from the right and left rear roller in order to adjust tension with the Hexagonal
Wrench provided in the parts package. The adjustment bolt is located at the end of the rails as noted in diagram
below:
Left bolt
Note: Adjustment
Note:
Note:
Note:
Tighten the rear roller only enough to prevent slippage at the front roller. Turn both the right and left bolt clockwise
reasonably and inspect for proper tension. When an adjustment is made to the belt tension, you must also make a
tracking adjustment to compensate for the change in belt tension.
DO NOT OVERTIGHTEN - Over tightening will cause belt damage and premature bearing failure. . . .
6 6 6 6 .6. .6. .6. .6. Belt
Belt
Belt
Tracking
Tracking
Belt Tracking
Tracking Adjustment
This treadmill is designed to keep the belt reasonably centred while in use. It is normal for some belts to drift near
one side while the belt is running with no one on it. After a few minutes of use, the belt should have a tendency
check
check
the
the
running
running
check the
the running
running mat
silicone
silicone
based
based
spray
spray to to to to lubricate
spray
silicone based
based spray
hardware
hardware
hardware store.
store.
store.
store.
Adjustment
Adjustment
Adjustment is is is is thru
thru
thru the
thru
the small
the
the
Adjustment
Adjustment
Adjustment
mat
mat
for
for
proper
proper
mat for
for proper
proper lubrication
lubricate
lubricate
your
your
Treadmill.
Treadmill.
lubricate your
your Treadmill.
Treadmill. This
small
small hold
small
hold
hold
hold on
on the
on
on
the
the
the end
end caps.
end
end
caps.
caps.
caps.
lubrication
lubrication
lubrication
This
This
Can
Can be be be be purchased
Can
purchased
purchased
This Can
purchased from
Right bolt
16
from
from
your
your
local
local
from your
your local
local
Publicidad
Tabla de contenido
