Rockwell Automation Allen-Bradley PanelView 550 Instrucciones De Instalación página 14

All manuals and user guides at all-guides.com
14 PanelView 550 Terminals
To connect DC power to the PV550 terminal:
1. Secure the DC power wires to the terminal block screws.
2. Secure the Earth Ground wire to the correct terminal block screw.
ATTENTION
!
ATTENTION
!
3. Apply 24V dc power to the terminal.
Power Terminal Block (fixed)
+
40061-325-01(D)
Explosion Hazard - Do not connect or disconnect
equipment while circuit is live unless area is known to be
non-hazardous.
Do not apply power to the terminal until all wiring
connections have been made. Failure to do so may result in
electrical shock.
Earth Ground
DC Negative
DC Positive