Installation Steps; Care And Cleaning - AVS Ventvisor Deflector Instrucciones De Instalación

Installation Steps

Align visor to the previously cleaned surface. The lateral flange
attaches to the surface of the door above the trim. The front flange
will attach on top of the vent post.
front flange
vent
post
3
Apply pressure along all flanges to ensure proper adhesion of tape.
5
4 Piece Set
To install the pop out visor open the extended cab window first. The rear visor attaches with the same prepara-
tion methods as the front visor. Align the part across the top of the pop out window, making sure the bottom
6

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade
™
NOTE: Actual application may vary slightly from illustrations.
visor
edge of the visor lines up with the bottom edge of the front door visor.
Repeat Steps 1-6 for opposite side.
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2005 Lund International, Inc. All rights reserved.
, the Auto Ventshade
TM TM
Gently press the exposed areas of tape against the surface and
verify position. With the visor in its final position, remove the re-
maining tape liner by pulling on free ends.
door frame
tape
visor
cross section of visor in place
4
logo and the AVS logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
rubber
window
channel
window
Bottom edge of front
and extended cab visors
should line up