Gases - Inteco HARRIER 280 Instrucciones De Uso

SELECTION GUIDE OF WELDING PARAMETERS WITH REFERENCE TO THE MOST TYPICAL APPLICATIONS AND MOST
COMMONLY USED WIRES.
Wire diameter - weight per meter
Voltage
arc (v)
Low penetration for thin
16 - 22
SHORT - ARC
24 - 28
GLOBULAR-ARC
(transition area)
30 - 45
SPRAY - ARC

6.1.3 Gases

MIG-MAG welding is defined mainly by the type of gas used: inert for MIG welding (Metal Inert Gas), active for MAG welding
(Metal Active Gas).
Carbon dioxide (CO 2 )
Using CO 2 as a protection gas, high penetrations and low operating cost are obtained with high feeding speed and good mechanical
properties. On the other hand, the use of this gas creates considerable problems with the final chemical composition of the joints
as there is a loss of easily oxidisable elements with simultaneous enrichment of carbon in the weld pool.
Welding with pure CO 2 also creates other types of problems such as excessive spray and the formation of carbon monoxide porosity.
Argon
This inert gas is used pure in the welding of light alloys whereas, in chromo-nickel stainless steel welding, it is preferable using argon
with the addition of oxygen and CO 2 in a percentage of 2% as this contributes to the stability of the arc and improves the form of
the bead.
Helium
This gas is used as an alternative to argon and permits greater penetration (on thick material) and faster wire feeding.
Argon-Helium mixture
Provides a more stable arc than pure helium, and greater penetration and travel speed than argon.
Argon-CO 2 and Argon-CO 2 -Oxygen mixture
These mixtures are used in the welding of ferrous materials especially in SHORT-ARC operating mode as they improve the specific
heat contribution. They can also be used in SPRAY-ARC. Normally the mixture contains a percentage of CO 2 ranging from 8% to
20% and O 2 around 5%.
All manuals and user guides at all-guides.com
0,8 mm
Good penetration and
materials
60 - 160 A
Automatic fillet weld Automatic welding
with high voltage
150 - 250 A
Low penetration with Automatic welding
adjustment to 200 A with multiple runs
150 - 250 A
1,0-1,2 mm 1,6 mm
Good flat and vertical
melting control
100 - 175 A
120 - 180 A
Automatic welding
downwards
200 - 300 A 250 - 350 A
Good penetration
downwards
200 - 350 A 300 - 500 A
2,4 mm
Not used
melting
150 - 200 A
Not used
300 - 400 A
Good penetration, high
deposit on thick materials
500 - 750 A
33