Panasonic EY7552 Manual De Instrucciones página 7

Attaching or Removing
Bat tery Pack
1. To connect the battery pack:
Align the highlighted marker points and
attach battery pack.
• Slide the battery pack until it locks into
position.
Alignment
marks
2. To remove the battery pack:
Push the button and slide the battery pack
forward.
Button
III . OPERATION
WARNING
!
• Do not inhale any smoke emitted from the
tool or battery pack as it may be harmful.
[Main unit]
Switch and
Reverse Lever Operation
Forward
Switch lock
EY7552_EU.indb 7
CAUTION:
Forward Rotation Switch
Operation
1. Push the lever for forward rotation.
2. Depress the trigger switch slightly to start
the tool slowly.
3. The speed increases with the amount
of depression of the trigger for efficient
tightening of bolts. The brake operates and
the socket stops immediately when the
trigger is released.
4. After use, set the lever to its center position
(switch lock).
Reverse Rotation Switch
Operation
1. Push the lever for reverse rotation. Check
the direction of rotation before use.
2. Depress the trigger switch slightly to start the
tool slowly.
3. After use, set the lever to its center position
(switch lock).
CAUTION:
Variable Speed Control
Trigger
Forward/
CAUTION:
Reverse
- 7 -
To prevent damage, do not operate
Forward/Reverse lever until the socket
comes to a complete stop.
• To eliminate excessive temperature
increase of the tool surface, do not
operate the tool continuously using two
or more battery packs. Tool needs cool
off time before switching to another pack.
To set the center of a hole, pull the trigger
slightly to start the socket rotation slowly.
The more the speed control trigger is
pulled, the higher the speed becomes.
When operating the tool by depressing
the trigger, there may be a momentary lag
before rotation starts. This does not signal
a malfunction.
• This lag occurs as the tool's circuitry
starts up when the trigger is pulled for
the first time after installing a new battery
pack or after the tool has not been
used for at least 1 minute. Rotation will
start without any lag during second and
subsequent operations.
2013-10-30 14:07:16