REFLECTS 51759 Manual Del Usuario página 16

5) Assemble the base.
Insert the 8 -
1.5 cm dowels
into the ends
of the platform
supports.
If the dowels
are loose, add
a small drop of
glue.
1.5 cm dowels!
Insert the crankshaft (from step 1) through a support, and add the
crankshaft spacer.
Slide the spacer
all the way to
the right.
15
Add glue to the dowel and the edge of the spacer
and slide up the large gear to the spacer.
Great -
let the glue dry!
51759 AL.indd 17
21
Slide the crankshaft
all the way up!
Small
amount!
7
21
Add a small amount of glue
to the shaft so the spacer
is glued to it, but no glue
on the support!
Insert and glue the 17 cm thicker dowel (main
shaft) into the small gear.
0,7 cm
NOTE:
The dowel should
be 0.7 cm from the
bottom of the gear.
Nice!
10
25.06.2013 14:07:19