REFLECTS 51759 Manual Del Usuario página 18

7) The base - continued!
Glue the platform
on the supports.
Make sure it is ali-
gned correctly first,
then add the glue!
Add the
inner
ring.
Add the drum.
Test the crankshaft. If it binds, gently sand and round the ends of the pegs on the
large gear.
If you look carefully at Leonardo's drawing, it seems he thought there should be runs
for the men to push against on the inner ring. You can draw a few on if you wish! We
like the natural look though.
51759 AL.indd 19
Glue into
place and
gently test
the cranks-
haft.
It turns
Counter-
clockwise!
This support
is close to
the edge.
Assemble the
pushing drum.
3,5 cm x 4
12 13
Thin dowels!
Nice, this doesn't need to be glued.
Easy!
Snack time!
25.06.2013 14:07:19