REFLECTS 51759 Manual Del Usuario página 17

6) Assemble the base - continued!
Lay out the base so the holder is as
shown - It is not in the centre!
Note: The two supports are oriented
with the smaller distance at the
bottom!
Top
Bottom
Insert the other support
and glue down.
5,3 cm
Looks great, you
are a master!
51759 AL.indd 18
Holder on base to
one side.
6,3 cm
5,3 cm
Insert the small gear in
the holder on the base.
Crankshaft
on this
side!
Insert the
support and
mesh the
large gear
with it.
Glue the other two
supports down!
Line up the lower platform as shown, centre hole to
one side.
25.06.2013 14:07:19