Fine Tuning - REFLECTS 51759 Manual Del Usuario

10) Add the canopy to the base
Carefully press the mast onto
the drive shaft. It is a pressure
fit, so it will only push down a
small amount.
If the hole is a bit loose,
just tear off a small strip of
paper from the edge of this
manual, add a bit of
glue, and lay it on
top of the drive
shaft so it is tight
(add a bit more
glue!).
Too tight? -
use the
sandpaper!

Fine tuning

Gently turn the handle and
make sure the upper canopy
and ring rotate without
rubbing on the lower
platform.
A nice
little gap!
11) The String.
You can remove the upper
structure to add the
string if you wish
(unless you glued it on).
Take the 4 strings and tie
them to the screw eyes,
then one wrap around
the bar and an overhand
knot on the top bar.
Add a drop of glue to each
place then trim the string.
51759 AL.indd 22
The outer ring shouldbe in
the air, and not rub on the
lower platform (see fine
tuning, below).
Adjust the height
at the collar
as needed!
Spaces
here!
SGently slide the collar up or down
to move the ring up or down as
needed.
Once perfect, add a small drop of
glue to the bottom and top edge of
the collar to hold it in place.
Tie them all on and then you are
ready to spin!
25.06.2013 14:07:21