Publicidad
Step 22
Place your unit in its fi nal location against a wall.
å
NOTE: The following instructions show your unit being fastened to a wall stud. If you are not fastening your unit to a
å
wall stud, go to the next step now.
1
st
- Locate the center of a stud in your wall near your unit and mark it with a pencil.
å
nd
2
- Drill a 1/8" hole on the mark and into the stud in your wall.
å
rd
3
- Fasten the unit to the wall. Use the LONG SCREW through the other end of the SAFETY STRAP and into the 1/8" hole.
å
Mark and drill
a 1/8" hole into
the wall stud.
st
1
429579
Electric drill with 1/8" bit
nd
2
rd
3
96
www.sauder.com/service
Page 27
Publicidad
