Maintenance, Service And Repairs - WELDY sealer GW800 Manual De Instrucciones

Troubleshooting
Hot wedge do
not heat
Hot wedge is
burned red
Chain
jumping
Accessories
• Only WELDY accessories must be used:
Article: Fuse 4A
Article: Fuse 1A
Article: Screwdriver
Article: Inner hexagonal spanner
Article: Silica gel wheel
Article: Hot wedge (spare part)

Maintenance, Service and Repairs

• The complete machine should be cleaned, greased and placed in a dry place if it is not used.
• For PVC welding, the adhesions on hot wedge should be cleaned off if it is not used longer than 4 hours
to prevent wedge corrosion and service life being shortened.
• Recommended: For welding of material that corrosive gas may be produced after hot fusing such as PVC
and the like, stainless steel hot wedge (optional accessory) is preferred for extending of service life.
• Repairs should only be carried out by Weldy-partners. Restricted to use with original Weldy accessories
and spare parts.
Warranty
• For this tool, the guarantee or warranty rights granted by the relevant distributor/seller shall apply. In case of
guarantee or warranty claims any manufacturing or workmanship defects will either be repaired or replaced
by the distributor at its discretion. Warranty or guarantee rights have to be verified by an invoice or a delivery
document. Hot wedge shall be excluded from warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandatory provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and tear, overload or improper handling.
• Warranty or guarantee claims will be rejected for tools that have been altered or changed by the purchaser.
8
Tubular electric heating element damaged Replace hot wedge assembly
Thermocouple failure
Temperature control knob loosened
Temperature control circuit board damaged
Thermocouple failure
Controlled silicon disruption
There may be sand or small stones on
chain and gear
Replace thermocouple
Tighten temperature control knob
Replace temperature control circuit board
or control box assembly
Replace thermocouple
Replace controlled silicon or control box assembly
Remove sand or small stones
10 pcs.
10 pcs.
2 pcs.
2 pcs.
1 pair
1 pc.