1.
A 10A safety fuse should be installed on the power supply code, and use a single grounded
socket.
2.
Don't extent the power code or add other electrical load.
3.
compressor start operating. Keep operating 30 minutes, put hands both onto the outside and
inside. If hot outside and cool inside, that means the appliance work normally.
4.
During operation, turn the temperature to mid position. Turn it to the highest position while
need freeze.
5.
Clean the frost when it reach 3-4mm on the evaporator. This series refrigerators are semi-au-
and dry the tray and the inside body.
6.
Try not to open the door too often.
7.
Don't cool bottle bear or drink in the freezer room, to avoid frost cracking or blasting.
Defrost Push-button
8.
Do not store flammable, highly volatile and eroded goods.
9.
Do not scratch the evaporator by any sharp substance, for that will broke the evaporator.
10.
Disconnect the power bar before cleaning the appliance. Use soft cloth to wipe with warm
water or neuter cleaning agent, and then clean it with water.
11.
Keep the door gasket clean, on order to maintain well seal.
12.
Use soft cloth or soft brush to clean the dust on the compressor and suction tube. Don't
wash it by water.
13.
Addition: Do not wash it by water directly, in order to prevent rust or reduce insulation of the
appliance.
Addition: Do not wash it by water directly, in order to prevent rust or reduce insu-
lation of the appliance
Correct operate and maintenance
English-4
Defrost Push-button