Verify Anti-Tip Bracket Is Installed And Engaged - Whirlpool WGG745S0FS Instrucciones De Instalación

Complete connection
1. Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A
A. Closed valve
B. Open valve
2. Test all connections by brushing on an approved
noncorrosive leak-detection solution. If bubbles appear, a
leak is indicated. Correct any leak found.
3. Remove cooktop burner caps and grates from parts
package. Align recess in burner caps with pins in burner
base. Burner caps should be level when properly positioned.
If burner caps are not properly positioned, surface burners
will not light. Place burner grates over burners and caps.
4. Plug into a grounded 3 prong outlet.
10
1. Place the outside of your foot against the bottom front of the
B
2. Slowly attempt to tilt the range forward.
3. If the rear of the range lifts more than 1/2" (1.3 cm) off the
IMPORTANT: If there is a snapping or popping sound when
lifting the range, the range may not be fully engaged in the
bracket. Check to see if there are obstructions keeping the range
from sliding to the wall or keeping the range foot from sliding
into the bracket. Verify that the bracket is held securely in place
by the mounting screws.
4. Slide the range forward, and verify that the anti-tip bracket is
5. Slide range back so the rear range foot is inserted into the
IMPORTANT: If the back of the range is more than 2" (5.1 cm)
from the mounting wall, the rear range foot may not engage
the bracket. Slide the range forward and determine if there
is an obstruction between the range and the mounting wall.
Changes to the gas supply must be performed by a qualified
service technician. If you need assistance or service, refer to
the "Assistance or Service" section of the Use and Care Guide,
or the cover or "Warranty" section of the User Instructions, for
contact information.
6. Repeat steps 1 and 2 to ensure that the range foot is
Verify Anti-Tip Bracket Is Installed and
Engaged
oven door to keep the unit from moving, and grasp the lower
right or left side of the control panel as shown.
NOTE: If your countertop is mounted with a backsplash, it
may be necessary to grasp the range higher than is shown in
the illustration.
If you encounter immediate resistance, the range foot is
engaged in the anti-tip bracket.
floor without resistance, stop tilting the range and lower it
gently back to the floor. The range foot is not engaged in the
anti-tip bracket.
securely attached to the floor or wall.
slot of the anti-tip bracket.
engaged in the anti-tip bracket.
If the rear of the range lifts more than 1/2" (1.3 cm) off the
floor without resistance, the anti-tip bracket may not be
installed correctly. Do not operate the range without anti-
tip bracket installed and engaged. Please reference the
"Assistance or Service" section of the Use and Care Guide,
or the cover or "Warranty" section of the User Instructions,
to contact service.