Sony SU-XTQ005 Guia Del Usuario página 5

CAUTION
If the following precautions are not observed,
injury or property damage may occur.
Do not install any equipment other
than the specified product.
This stand is designed for the use with the specified
product only. If you install equipment other than
specified, it may fall or break, and cause injury.
Be sure to secure the Display Unit.
Secure the Display Unit to the Table-Top Stand using
the supplied screws. If the Display Unit is not installed
securely, it may fall, or the stand may topple over, and
cause injury.
Notes on installation
• Install the stand on a solid and level floor. Be sure
the stand is placed where it will not be deformed or
inclined. To avoid this, observe the following
precautions.
– If you install the stand on a soft surface such as a
mat or a carpet, lay a board over the designated
location beforehand.
– Do not install the stand in a place subject to direct
sunlight or near a heater.
– Do not install the stand in a hot or humid place, or
outdoors.
• The Table-Top Stand swivels 18 degrees to the left
and right. The stand swivels on a turntable at the
bottom of the stand. If you place the stand on a
narrow shelf, a part of the stand will protrude from
the front edge, or the Display Unit will hit the wall.
This may cause serious injury or damage by falling
down. Observe the following.
– Place the stand at least
8 cm (3 1/4 inches) back
from the front edge of the
shelf.
– Place the stand at least
10 cm (4 inches) away
from the wall.
Note on use
Cleaning
To keep the stand clean, occasionally wipe the stand
with a dry soft cloth. Stubborn stains may be removed
with a cloth slightly dampened with diluted detergent.
Then wipe the area with a dry soft cloth. Do not use
chemicals, such as thinner or benzine, as they damage
the finish of the stand.
For Sony dealers
Be sure to thoroughly read the
safety precautions described on the
previous pages and pay special
attention to safety during the
installation, maintenance, checking,
and repair of this product.
Be sure that two or more persons do
the installation work.
Be sure that two or more persons install the Display
Unit on the Table-Top Stand. If necessary, include
another person to support the rear of the Display Unit.
Do not attempt to install the stand by yourself. If you
do so, it may lead to an accident or injury.
Be sure to install the Display Unit
securely by following the
instructions.
Tighten the screws securely. If the Display Unit is not
installed securely, it may fall and cause injury.
Be careful not to injure your hands or
fingers during installation.
Be careful not to injure your hands or fingers when
attaching the Display Unit to the Table-Top Stand.
US
3
(US)