Dantherm CDT 30 MK III Manual Del Usuario página 16

User guide,
Text displays when
not connected to
mains
Replacing the
memory battery
14
cont.
The machine has a built-in battery to allow reading text displays when not connected to
the mains. The following texts can be read when not connected to the mains:
Key
hold down
and
press once
hold down
and
press once
If the hour counters cannot be read when disconnected from mains, it is probably due
to flat memory battery. Replacement procedure:
Action
Warning: Always disconnect from the mains before changing battery
1 Slacken the screws on
both side of the control
panel, and carefully lift
the panel up using the
top edge
2 Cut the cable tie holding the battery. Replace the battery, using a new cable tie
max. 2.5 mm wide.
Use Alkaline AAA batteries only
Illustration of PCB with battery included in the wiring diagram on page 29.
Displays total energy consumption in kWh
Shows total number of operating hours for the dehumidifier
Feedback
Continued on next page