Remote Control Operation; Side View; Remote Effectiveness; Top View - Friedrich SS08 Manual De Instalación Y Operación

Remote Control Operation

Remote Control - Refer to Figures 12 and 13 during operation description.
Getting Started - Install two (2) AAA batteries in the battery compartment
located on the back of the unit.
Operation - The remote control should be within 25 feet of the air
conditioner for operation. (Refer to Figure 11 for effectiveness). Press the
power button to turn the remote on. The remote will automatically power
off after 15 seconds if the buttons are not being pressed. The remote must
be on to control the unit.
POWER Button - Turns remote and unit on and off.
SYSTEM Button - Allows the user to sequentially select the
following: AUTO - AUTO -, COOL
operations. When the button is pressed, the display indicates which mode
has been selected via a display message.Note that when the heating
function is not available, the system will
FAN MODE Button - Selects between automatic (
operation. In the mode, the fan only turns on and off when the
AUTO FAN
compressor operates or the heat function is enabled.
NOTE: is not available in the FAN ONLY Mode, the display
AUTO FAN
indicates . In the
CONTINUOUS
determined by your selection on the
Figure 11

SIDE VIEW

20
All manuals and user guides at all-guides.com
, HEAT , and FAN ONLY
automatically skip the HEAT mode.
) or
AUTO FAN CONTINUOUS
mode, fan speed is
CONTINUOUS
button.
F A N
SPEED
7.5ft
30°
45°
60°
60°
45°
30°
8ft
FAN SPEED Button - Used to sequentially select new fan speed, plus
AUTO operation. When the
(triangle) changes to indicate the new speed level. Fan speed automatically
varies depending on the set temperature on the control panel and the actual
room temperature. For example if there is a big difference between your
set temperature and the actual room temperature, the system fan speed
increases to HIGH. It remains at this speed until the room temperature
matches the set temperature.
SCHEDULE Button – The
on and off. Press the Schedule button once to turn on the Schedule
(Residential, Commercial, Timer, or Customized) that has already been
selected on your unit. Pressing the
the schedule function off.
UP and DOWN Arrows - Pressing either the
button changes the desired room temperature. The factory preset lower
and upper limits are 60°F (16°C) and 99°F (37°C). These buttons are also
used to navigate between function options when using the User Menu or
Maintenance Mode.

Remote Effectiveness

Hand Held Remote - Has an operating range of up to 25 ft. The infrared
remote control signal must have a clear path to transmit the command to
the air conditioning unit. The remote signal has some ability to "bounce"
off of walls and furniture similar to a television remote control. The diagram
below shows the typical operating range of the control in a standard room
with 8 ft high ceilings.
25ft
25ft
25ft
25ft
25ft
25ft
button is pressed, the fan speed icon
F A N
SPEED
button turns the schedule function
SCHEDULE
button a second time turns
SCHEDULE
(UP) or

TOP VIEW

4ft 60°
60°
6ft
45° 45°
8ft
30° 30°
25ft
(DOWN)
16ft
25ft
FRR080