Friedrich SS08 Manual De Instalación Y Operación página 31

STEP 10. INSTALL THE R1 INSULATION PANEL – To
minimize air leaks and ensure optimal insulation, install the
included R1 insulation panel. (14 in parts list) (See Figure 28
A-C).
First, measure the width from one side of the cabinet/sleeve
(covering the side angles where the wingboard was just
secured) to the end of the wingboard. (See Figure 28A)
Next cut the R1 insulation panel to the measured width and
remove protective cover, exposing adhesive on back panel
(See Figure 28B)
Last, evenly apply the adhesive side of the panel across the
entire height and width from side angle to wingboard panel.
(See Figure 28C)
Repeat the steps above for the other wingboard panel.
STEP 11. INSTALL THE WINDOW SEALING GASKETS – Measure
and cut the dark foam window seal gasket (Item 12) and
install it between the upper glass panel and the top part of
the window sash (Figure 29).
CAUTION
Excessive Weight Hazard
Use two or more people when
installing your air conditioner.
Failure to do so can result in
back or other injury.
Figure 26
"J" TYPE SPEED NUT
(ITEM #9) 2 REQUIRED
CUT
WINGBOARD
PANEL
CENTER THE HOLE IN THE
SPEED NUT OVER THE SLOT
IN THE WINGBOARD PANEL
All manuals and user guides at all-guides.com
3"
CAUTION
Cut/Sever
Although great care has been
taken to minimize sharp edges
in the construction of your unit,
use gloves or other hand
protection when handling unit
Failure to do so can result in minor
to moderate personal injury.
STEP 12. Carefully team lift the chassis and set it into the cabinet. Slide
the chassis stopping approximately 3" from full insertion. Insert
the chassis seal gasket (Item 13) one inch deep between the
chassis and the cabinet (See Figure 31) as shown on page
33. A paint stir stick or ruler might be helpful here. Begin
inserting the gasket at either bottom corner and go up the
side, across the top, and down the opposite side. Then push
the chassis all the way into the cabinet.
NOTE: If the chassis seal gasket is not installed or installed improperly,
the operation of the unit will be negatively affected. Operational
STEP 13. Reattach the entry guard chassis entry guard retainer wire with
the same screw retained in Step 1 (See Figure 15).
SPRING STEEL
CLIP (ITEM 10)
2 REQUIRED
3"
CUT EDGE
SLIDE CLIP OVER CUT EDGE
OF WINGBOARD PANEL
ROTATED 90°
FRR021
31