Schlage FE595 Instrucciones De Instalación página 2

Install Lock
1
Install latch.
Make sure latch angle faces door jamb.
Angle
Actual Size
2
Install strike onto door jamb.
3
Prepare keypad.
Remove sticker from hands-free post.
Jamb
OR
Wood Block
(Not Included)
Actual Size
Hands-free Post
4
Install keypad
Angle
5
Adjust hands-free post.
The hands-free post holds the keypad and baseplate together while
installation is completed.
6
Install baseplate.
7
Connect wire and battery.
IMPORTANT
Wire must slide
under latch.
Bar should slide
smoothly through
hole in latch. If
not, check door
dimensions.
Loosen post until it
extends ¹⁄₈" (3 mm)
to ¹⁄₄"(6 mm)
beyond door face.
¹⁄₈" (3 mm) – ¹⁄₄" (6 mm)
Route wire through
opening as shown.
Snap baseplate onto hands-free post.
The hands-free post will hold the lock
on the door.
Lock will beep when
battery is connected.