Electrical Diagram - Zummo Z40 Manual Del Usuario

The display shows message
Error
The display shows message
Error and a flashing Icon.
Blocked machine
Blade breaks
The filter cleaner is not
removing the pulp from the
filter
Not enough juice is being
extracted from the fruit
Hooper is not delivering fruits
so the squeezing area
Hooper is delivering several
oranges at the same time into
the squeezing area
For any advice or to request spare parts, you should state the model and serial number of your machine (Fig. 5).
16

ELECTRICAL DIAGRAM

1 Fuse
2 Power switch
3 Circuit board
4 Motor
5 Condenser
6 Tray micro-switch
22
Front cover not fitted correctly. (Fig. 32)
Tray not assembled or incorrectly assembled. (Fig.33a-33b)
Side covers not fitted correctly. (Fig. 34)
Overheating motor.
See section SAFETY SYSTEMS.
Check if the fruit is frozen.
Check for piled-up fruit peels inside the Juice tray.
Check if Balls are correctly tightened.
Check to see if the orange peels are stuck to the inside of the Cups.
Check if components of different squeezing sets are mixed.
The skin of the fruit may be too thick. Remove the washer from underneath the ball.
To unblock the machine, use the 5mm Allen key located at the right of the lower lid.
Insert it into the hole on the right side and, with the machine switched off, turn
anticlockwise until the cups are raised, removing the obstruction. WARNING: Make
sure the Allen key is removed before switching the machine on.
Cup nuts are too loose.
Balls are loose.
A piece of orange peel is preventing the movement of the pulp scraper filter.
The filter set has been assembled in reverse. Check that the drive shaft dovetails
properly with the hexagonal actuator (Fig. 22a-22b)
The ball washers (which are placed underneath the balls) are missing.
Fruit peel is too thin. Place one extra washer under each ball.
Fruit is too big for the fruit classifier in use.
Check the position of the lower fruit classifier. (Fig. 8a)
Fruit is too small for the fruit classifier in use.
Check the position of the lower fruit classifier. (Fig. 8b)
Hopper not properly assembled. See cleaning the feeder in section cleaning.
7 Front cover magnetic sensor
8 Left side cover micro-switch
9 Right side cover micro-switch
10 Counter micro-switch
11 Self service magnetic sensor
12 Fan