Start Up; Stopping; Counter Function - Zummo Z40 Manual Del Usuario

4

START UP

 Depending on the size of the oranges to be squeezed, select the correct size of cup and ball and the fruit
classifier for the basket and position the lower fruit classifier correctly (Fig. 8a-8b). See the section on
MACHINE ACCESSORIES.
 Fit all the parts in their correct positions. See assembly in the section on CLEANING THE MACHINE. If
you have a service model (with a tank), fit the support on the base of the machine (Fig. 9).
 ATTENTION!!!: Do NOT place your hand into the basket while the machine is operating (Fig. 10).
 Z40 or Z40 Service Model
- Once the machine is switched on, the display will show either a number between 1 and 50 or the
letter C. The number indicates the quantity of fruits to be squeezed, while the letter C sets the
machine to squeeze continuously for approximately 30 minutes.
- To st the number of oranges to squeeze, press the SELECT button repeatedly to increase the
number (from 1 to 50, followed by the letter C; 1,2,3,..........48,49,50,C,1,2,3.....). Alternatively, press
and hold the SELECT button for 2 seconds and the number will decrease. Continue until you
visualize the wanted number.
- The selected number will be stored on the display after the first complete squeeze cycle is finished.
The number will be stored even if the machine is switched off. You may change the number
repeating the complete number selection process.
- Press the ON button to start squeezing. During the process, the display will show the remaining
amount of fruits to be squeezed. If you wish to repeat the process, simply press ON. To stop the
process, press the STOP button.
 Self-service Model
- Once the machine is turned on, the screen displays an orange icon. This means that the machine is
ready to squeeze fruit.
When you press the tap down, the juicer will start working and the screen will display a Clock icon
-
and the word "Run", while the machine is working. In order to stop the machine, just release the tap.
5

STOPPING

(Z40 or Z40 service Model) To stop the machine when is operation, press the Stop button. The display will
show a timer and the message Stop. The machine will stop once finish the cycle. Once the machine
completely stops, the display will show again the number of fruits to squeeze.
(Self-service Model) Once you release the tap, the juicer will finish the cycle, and the digital screen displays
a "Clock icon and a Stop sign". Once the machine stops, the screen will display an orange icon, indicating
that the juicer is ready to squeeze again.
6

COUNTER FUNCTION

The display stores the total number of cycles* completed. To visualize the figure,
With the machine stopped and in stand-by, press the STOP button

The figure will appear on the display for a few seconds.

17