Disconnecting And Shutting Off The System; Changing The Bottle - Lacor Ice Manual De Instrucciones

5. DISCONNECTING AND SHUTTING OFF THE SYSTEM

If your LACOR model has an (ON/OFF) button, turn it off by pressing it.
Disconnect the equipment from the electricity network.
Whenever you are going to stop using the equipment, you should perform a purge. To
carry this out, you should first close the bottle by turning the thread to the left (11), and turn
the petcock (12) to the right. Once the gas has finished releasing, close the petcock to the left.
11. Bottle shutoff valve
12. Petcock

6. CHANGING THE BOTTLE

Follow the steps from Section 5. Next, release the safety cable for the CO2 bottle. Release
the thread from the head of the connection to the regulator with by hand. Remove the emp-
ty bottle. Connect a new bottle, again with the thread at the head of the connection to the
regulator, by hand.
Connect the safety cable to the bottle shutoff valve.
Connect the LACOR model network cable to the 220V electricity network.
Verify that the network cable is also connected to the LACOR equipment.
If the model has a Power Switch, press it; if it does not have one, it will turn on automatica-
lly when connected to the electricity network.
Verify that the petcock (12) is closed and next, open the bottle shutoff valve (11), turning
it to the right.
11. Bottle shutoff valve
12. Petcock
1
2
1
2
EN
Image 6
Image 7
29