Chicco MULTIRIDE Manual Del Usuario página 8

WARNING: Before installing the Child Car Seat,
check that the adaptors are mounted correctly.
4. To install the Chicco KIROS I-SIZE FAST IN
Child Car Seat, recline the stroller's backrest
and then insert the lateral hooks of the child
car seat into the adaptors previously mount-
ed (Fig. 4). The car seat should be fixed only
and exclusively facing parent.
5. To remove the KIROS I-SIZE Child Car Seat,
press the buttons under the handle on both
sides and pull upwards (Fig. 5-5A).
DISASSEMBLING THE ADAPTORS
WARNING: It is not possible to close the stroller
when the adaptors are mounted on the frame.
6. To release the adaptors, turn the plastic levers
outwards (Fig. 6) and pull the adaptors to-
wards you. Once the adaptors have been un-
hooked, the bumper bar previously removed
must be fixed back on again.
ADVICE FOR CLEANING AND MAINTE-
NANCE
The cleaning and maintenance of the product
must only be carried out by an adult.
CLEANING
After possible contact with water, dry the metal
parts in order to avoid the formation of rust. Do
not use solvents or abrasive products for clean-
ing. After use, keep the adaptor in a dry place.
WARRANTY
The product is guaranteed against any con-
formity defect in normal conditions of use as
stated in the instructions. Therefore, the warran-
ty does not apply in the case of damage caused
by improper use, wear or accidental events. For
the duration of warranty on conformity defects,
please refer to the specific provisions of nation-
al laws applicable in the country of purchase,
where provided.
8