Connecting With Your Phone; Wearing Style - Jabra ARROW Manual Del Usuario

3 Your phone will find the Jabra ARROW
- Your phone will find the headset under name "Jabra arrOW" .
Your phone then asks if you want to pair with the headset .
accept by pressing 'Yes' or 'OK' on the phone . You may be asked
to confirm with a passkey or PIN . Then use 0000 (4 zeros) . Your
phone will confirm when pairing is complete and the light on
the headset will flash a few times to confirm pairing .
CONNECTIVITY
MobilSurf
BLUETOOTH
Infrared port
Wap options
Synchronization
Networks
SELECT
Manual pairing mode
If you wish to use the headset with a different phone, or if the
pairing process was interrupted, you can manually set the headset
to pairing mode .
Make sure the headset is on . Press and hold the answer/end
button for approximately 5 seconds until the
turns from a steady light to a flashing light . Then repeat steps
2 and 3 in the above pairing guide .

ConneCtInG WItH YoUR PHone

Pairing is only needed the first time a headset and phone are
used together . When the headset and phone have been paired
once, they will automatically connect when the headset is on and
is activated on the phone . The headset can be used
when it is "connected" to the phone . If the devices are paired, but
do not immediately connect, tap the answer/end button .

WeARInG stYLe

The Jabra arrOW can be worn on either ear with or without ear
hook . The ear hook can be removed and the headset can be worn
with one of the Ultimate Comfort Eargels
ear gel with a small, medium or large Ultimate Comfort Eargels
included in the pack . You can twist the ear gel slightly to optimize
fit and comfort .
DEVICES FOUND
Jabra ARROW
SELECT
Jabra arrOW
Jabra ARROW
Passkey:
****
OK
. replace the standard
TM
HANDSFREE
Jabra ARROW
added.
The handsfree is
now ready for use
SELECT
icon
TM
5