Loading The Bottom Rack - Bosch SHE66C Manual De Uso Y Cuidado

Preparing and Loading the Dishware
Top Rack Height Adjustment
(models SHV56C and SHX56C only)
Remove the empty upper rack by pulling it out of
the dishwasher to the point that it can be lifted
upward, as shown in Figure 6.
Pull the rack outward and up until the rollers are
completely free of the roller guides.
Re-insert the rack with the other set of rollers on
the roller guides, as shown in Figure 7.
Figure 6
Cup Shelves
In addition to cups, the cup shelves can also hold
large utensils.
Grasp the cup
shelves as
shown in
Figure 8 and
fold them down.
Place cups
upside-down on
the cup shelves.
Knife Rack
(models SHE66C, SHX57C and SHV57C only)
The knife rack is an
extra shelf for
knives and other
large utensils. It is
assembled onto an
edge of the upper
rack.
Place knives with
sharp sides down,
see Figure 9.
Figure 7
Figure 8
Figure 9
(continued)
Top Rack Only™ Cycle
This cycle allows you to save energy, water, and
detergent by washing loads small enough to fill
only the upper rack.
NOTE : The Top Rack Only™ cycle does not
reduce wash time.
To use the Top Rack Only™ cycle:
1. Load the top rack.
2. Press the On/Off button.
3. Press the button for the desired wash cycle.
4. Press the Top Rack Only button.

Loading the Bottom Rack

Place large items in the bottom rack. Load pots
and pans
upside-down.
Figures 10
and 11 show
typical
mixed loads
for the bottom
rack.
Figure 11
12 place setting
Figure 10
7