Maintenance; Troubleshooting; Accessories; Disposal - Rothenberger ROTHERM 2000 Instrucciones De Uso

 Attach soldering tongs (1) and press pneumatic switch (2) (green control lamp light up).
Control of soldering temperature is better by simultaneously applying the filler wire.
The heating of the fittings depends on the material used and the wall thickness.
 Feed in the solder until the soldering gap is filled and release the switch (2) (green control
lamp off).
 Remove the soldering tongs (1) from the workpiece.
When the soldering tongs is laid aside, attention should be paid to ensure that objects in
the immediate working vicinity are protected from direct contact with it!
 Remove plug from mains socket (red control lamp off).
4

Maintenance

Repairs should only be carried out by ROTHENBERGER service centres or dealers authorised by
ROTHENBERGER.
Check the electrodes and holders for damage and consumption.
Burned-out flat or stick electrodes should be replaced in good time. Replace the holders if
necessary.
5

Troubleshooting

The red "Input Voltage"control LED does not light up:
-
no input voltage
-
defective mains cable
-
the red control LED is defective
-
the fuse in the main unit is defective.
The green control LED does not light up:
-
the pneumatic circuit has not been activated
-
the air intake to the pneumatic circuit has been interrupted
-
a vacuum has developed in the air in-take
-
the overload protection has switched off the unit temporarily.
6

Accessories

The relevant accessories and an order form can be found from Page 58 onwards.
7

Disposal

Components of the unit are recyclable material and should be put to recycling. For this purpose
registered and certified recycling companies are available. For an environmental friendly disposal
of the non-recyclable parts (e.g. electronic waste) please contact your local waste disposal
authority.
For EU countries only:
Do not dispose of electric tools with domestic waste. In accordance with European
Directive 2002/96/EC on waste electrical and electronic equipment and its
implementation as national law, electric tools that are no longer serviceable must be
collected separately and utilised for environmentally compatible
ENGLISH
recycling.
11