Publicidad
Idiomas disponibles
Idiomas disponibles
8
A min.
B min.
(mm)
(mm)
D
1.500
350
Tools required
• Ruler
Page 3:
Mounting steps
Lamps should not vibrate or extend
above the bonnet and must be
attached symmetrically.
When mounting auxiliary lamps
with integrated position light it is
necessary to observe certain
mounting dimensions. If these
statutory mounting regulations are
not observed, or if the use of an
additional pair of position lamps is
not permissible do not operate the
position lights.
C min.
D min.
(mm)
(mm)
Leave the lamp socket in the
auxiliary lamp to prevent leakage.
400
600
• Combination pliers
• Pliers for crimp connectors
(if available)
• 13,17 mm open end or box wrench
Determine mounting position on flat
surface and mark mounting points.
Drill pilot hole with 3 mm dia. bit and
then bore out to 11 mm.
Protect drilled metal parts with rust
protection paint.
Preliminarily install mount.
Page 3:
Fig. A
Open housing and install bulb 1 .
For position light version:
install bulb 2 .
, A
, B/C
1
2
Statutory operating approval in
various countries for position light:
F
D
A
S
CH
NL
GB
permissible according to law
not permissible according to law
• Drill with 3, 5, 11 and 12 mm dia. bits
• 3 and 6 mm Allen keys
• Screwdriver for recessed-head screw
Do not touch bulbs with bare fingers!
Use tissue paper or similar.
Assemble housing.
Screw holder and housing together
and route cable cleanly.
Screw lamps to vehicle (use two-
point mount if required).
Align lamps and tighten screws.
E
I
FIN
Publicidad
