Mounting - THERMEx SWINDON Instrucciones De Montaje

M 545217062223072015

MOUNTING

The Swindon is a wall-mounted range hood. When assembling, the hood must be installed
first, after which the duct is installed onto the hood.
INSTALLING THE DRAFT DAMPER
Before the hood is mounted onto the wall, the draft damper must be mounted onto the hood.
This is done to prevent cold air being pulled through the hood.
The draft damper shall be installed as follows:
1
THERMEX SWINDON 57
Attach the two valves to the draft
damper on the flange on top of the hood.
NOTE: The pins in the middle of the
valves must be facing upward.