Publicidad
When circle cutting, adjust rip fence so that distance
from blade to hole in fence arm is at the desired radius
and tighten screws. Place saw so that the hole in fence
arm is over centre of circle to be cut (drill hole for
blade or cut inward from edge of material to get blade
into position). When saw is properly positioned, drive a
small nail through hole in fence arm. Using rip fence as
a pivot arm, begin cutting circle. For circle cutting, the
cross bar should be up, as shown in figure J.
MAKING A POCKET CUT (FIGURE K), IT IS NOT
NECESSARY TO DRILL A PILOT HOLE:
•
Mark the desired starting point
•
Tilt the tool forward and place the rounded
front edge of the saw shoe on the workpiece
so the blade does not touch the surface
•
Switch the tool on and slowly feed the saw
blade into the workpiece at the desired
starting point.
Problem
• Unit will not start
3
All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
TROUBLESHOOTING
Possible Cause
• Cord not plugged in
• Circuit fuse is blown
• Circuit breaker is
tripped
• Cord or switch is
damaged
10
Possible Solution
• Plug tool into
a working outlet
• Replace circuit fuse
(If the product
repeatedly causes the
circuit fuse to blow,
discontinue use
immediately and have
it serviced at center or
authorized servicer).
• Reset circuit breaker.
(If the product
repeatedly causes the
circuit breaker to trip,
discontinue use
immediately and have
it serviced at a
service center or
authorized servicer).
• Have cord or switch
replaced at a Service
Center or Authorized
Servicer
SIM
•
V -
Hz-
Min
-
-
pro
sfm
Des
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Publicidad
