Publicidad
•
Bevel angles are marked on a scale (15) located on the side of the shoe
(Fig. D)
•
Slide the base toward the rear of the jigsaw and align the bevel angle
index mark (16) with the desired bevel angle on the shoe.
•
Slide the shoe forward to engage the bevel angle slot (17) with the
indexing pin (18) (Fig. E)
NOTE: Use a protractor to check the bevel angle between the blade and the base.
NOTE: To set the bevel angle at intermediate angles, do not slide the base forward
•
Once the desired bevel angle is obtained, lock the shoe in place by
tightening pivot screws
•
Make a test cut in a scrap piece of material and measure the bevel angle.
Adjust the bevel angle if necessary.
SWITCHING ON AND OFF
•
To switch the tool on, squeeze the trigger
switch (1)
•
For continuous operation, squeeze the
trigger switch then depress the lock-on
button (2). Once lock-on button is
depressed, release the trigger switch
•
To switch the tool off, release the trigger
switch. To switch the tool o , when in
continuous operation, squeeze the trigger
and the lock will disengage.
VARIABLE SPEED CONTROL (FIGURE F)
•
A speed control wheel (7) is located on the
top of the saw. Rotating the variable speed
control wheel toward the rear of the jigsaw
will result in slower speeds. Position the
speed control dial at 1 for the slowest speed,
3 for the medium speed, and 6 for the
highest speed.
CUTTING ACTION – ORBITAL OR STRAIGHT
!
CAUTION: Check that the tool is not locked ON before connecting it to a
power supply. If the trigger switch is locked ON when the tool is connected to the
power supply, it will start immediately. Damage to your tool or personal injury may
result. The variable cutting action allows you to select one of four di erent cutting
actions.
•
To set the cutting action, rotate the cutting action lever (8) forward or
backward to the desired setting number (Fig. G)
•
Position 0 is straight cutting
•
Positions 1, 2 and 3 are orbital cutting
•
The aggressiveness of the cut increases as the lever is adjusted from one
to three, with three being the most aggressive cut.
3
All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
8
CO
!
rem
Los
der
•
•
•
•
NO
NO
•
•
EN
•
•
•
CO
•
Publicidad
