Publicidad
OPERATING INSTRUCTIONS
!
WARNING: Before attempting any of the following operations, make sure that
the tool is switched o
saw blades can be hot.
INSTALLING A BLADE
This jig saw accepts both T shank and universal blades
•
To install a blade (4) in the jig saw, push
upward on the blade locking lever (3) (Fig. A)
•
With teeth facing forward, insert the shank of
the saw blade into the blade holder as far as it
will go.
NOTE: Make sure the rear edge of the blade is nested in
the blade guide roller (5)
•
Release the blade locking lever
NOTE: The blade will automatically be locked into the
blade holder. Pull downward on the blade to ensure it is
properly locked into the blade holder.
REMOVING A BLADE
To remove a blade, push upward on the blade locking
lever (3) and remove the blade from the blade holder.
HEX KEY STORAGE
The 1/8" (3.125 mm) hex wrench (10) for adjusting the
edge guide and bevel cutting angle is stored in power
cord holder at the rear of the jigsaw.
RIP FENCE / CIRCLE GUIDE (not provided)
This jigsaw can be equipped with a rip fence / circle
guide that will assist in cutting narrow edges from a
workpiece.
•
Insert the rip fence (11) through the mounting
slots (12)
•
Set the rip fence at the desired distance from
the blade and lock it into place by tightening
the mounting screws (13) supplied with the
accessory.
•
Make a test cut on a scrap workpiece to ensure
the edge guide is set correctly.
•
Adjust the edge guide as required.
SETTING THE BEVEL CUTTING ANGLE
!
WARNING: Never use the tool when the shoe is loose or removed
Bevel cutting angles may be adjusted from 0° to 45° either left or right. To adjust
the bevel angle:
•
Loosen both pivot screws (14) until the shoe (6) can be rotated (Fig. C)
with the hex wrench (10).
All manuals and user guides at all-guides.com
and unplugged and that the saw blade has stopped. Used
7
1 7
Publicidad
