General Description - ROBBE POWER PEAK FUN Manual De Uso

2.

GENERAL DESCRIPTION

The Power Peak FUN is an intelligent charger with convenient battery management, desi-
gned for charging NC, NiMH and Lithium batteries.
The Power Peak FUN can be used to charge and discharge NC and NiMH batteries con-
sisting of 1 to 24 cells. The Delta Peak method is used to terminate the charge process
when the battery is fully charged. The unit can also charge up to six series-wired Lithium
cells. When the LiPo battery is fully charged, the process is terminated automatically
using a voltage-dependent cut-off method.
The Power Peak FUN offers a wide charge current range of 0.1 to 6.5 A, making it ideal
for slow-fly batteries and transmitter and receiver packs as well as for large drive batte-
ries or flight packs. The high charge current is particularly important, as it provides for
short charge times when used with high-capacity LiPo batteries.
The main feature of the Power Peak FUN is the ground-breaking Battery
Identification System (BID). A vast array of different battery types is now
available to the modeller, and the range is constantly expanding; the pro-
blem is that each battery type requires its "own" charge process. It can
happen so quickly: you switch the system on with the wrong settings - and
in a moment your valuable battery is damaged.
The revolutionary BID system from robbe now offers an inge-
nious solution to this problem. A small, lightweight BID chip is
assigned to each battery, and the chip stores all the relevant
data required for charging and discharging that pack perfect-
ly. When the battery is to be charged or discharged, the BID
chip attached to the battery is connected to the Power Peak
FUN, and the BID system transfers the required parameters to the charger.
Simply press the 'MODE' button to set the desired process, and the charge or discharge
process begins. No tiresome searching through menus for the set-up parameters, maxi-
mum protection from mis-handling, and storing of the relevant battery data in the BID chip
- those are the unique advantages of the BID system.
Since the essential information is stored in the BID chip, all the data required for safe,
optimum charging and discharging is always "on board" the battery, and can be display-
ed on the charger at any time This means that you can obtain an up-to-date picture of the
battery's condition without the need for PC software or computer technology.
Naturally the Power Peak Fun can also charge batteries not fitted with the BID system.
The unit then works as entirely normally, with the following functions:
• Charge,
• Discharge, and
• 1 or 3 x discharge -> charge, displaying all the charge parameters on the screen at the
same time.
All manuals and user guides at all-guides.com
Operating instructions
POWER PEAK FUN
25
Order No.
8467