Programming A Bid Chip; Menu Structure, Programming Procedure - ROBBE POWER PEAK FUN Manual De Uso

Tabla de contenido

Idiomas disponibles

All the displayed parameters are erased when you connect a battery, or when you

switch from discharge to charge. At the same time the stored capacity values are all

moved back by one (e.g. from M1 to M2).

PROGRAMMING A BID CHIP

If the charger is set to the Start display or any other set-up menu, new menu points

become available for programming BID chips as soon as a BID chip is connected to the

charger by means of the adaptor lead. The same applies if the charger is switched on

with a chip connected. Press the 'SELECT' button repeatedly until the screen shows the

following display. Starting from this menu you can set all the battery parameters which

7.1

'INC' / 'DEC'

button

'SELECT' button

'INC' / 'DEC'

button

All manuals and user guides at all-guides.com

Operating instructions

POWER PEAK FUN

are to be stored in the chip, using the procedure

already described.

Initial screen display for programming

a BID chip; press the 'INC' or 'DEC'

button to initiate the programming

procedure

Programming the battery type: use the

'INC' or 'DEC' button to select; the