Slime Expert Heavy Duty Inflator Guia De Inicio Rapido página 3

INFLATE TIRES
1
1. Securely screw air hose valve connector onto the valve stem.
2. Plug power cord into 12 volt accessory power outlet.
3. Turn on inflator. Inflate tire to manufacturer's recommended air pressure. Correct
tire pressure can be found in vehicle owner's manual or on driver's side door jamb.
Turn off inflator and unplug power cord and remove air hose connector.
4. If necessary, add the twist-connect extension green air hose for extra length.
INFLATE RIGHT™ TECHNOLOGY INSTRUCTIONS
1. Once inflator hose is attached to the valve stem, hold the + or – button for
approximately 2 seconds until the display flashes. Set the required pressure using
the + or – buttons, then wait 3 seconds. The display will show the pressure value
to which the tire will be inflated. (Continuously pressing the "+" or "-" button will
enter into "Fast setting mode", increasing or decreasing the rate of target pressure
at an increased speed.)
2. When the pressure gauge reaches the pre-set value, the inflator will automatically
stop inflation. Once desired tire pressure is reached, disconnect the air hose, and
unplug the power cord.
3. When the pressure gauge reaches the pre-set value, the inflator will automatically
stop inflation. Once desired tire pressure is reached, disconnect the air hose.
4. The ON/OFF button can be used to override the pre-set pressure value if required.
2 3