Publicidad
Installation
1 Use the torx L wrench provided as an accessory to remove the 2 fastening
bolts from the top cover by turning them counterclockwise, and remove
the mount.
2 Make sure the screw holes for mounting to ceiling are visible.
Screw holes for
assembly
3 Plug the lens module separately purchased in the holder.
4 Use the 2 installation screws provided as accessories to fix the bottom cover.
`
Although there are 4 screw holes for mounting to ceiling, you might have to use only 2 depending on the
surveillance angle.
Holder
Screw holes for mounting
to ceiling
5 Use the torx L wrench to assemble the top cover.
`
Make sure it aligns with the screw holes for mounting the cover.
6 Adjust pan/tilt to set it to a desired angle.
PT01-005715A
Publicidad
