Store The Machine; Troubleshooting; Technical Data - GreenWorks 2605302 Manual Del Operador

30
8. Reinstall the nut (27) and right side cover.
27
9. Reinstall the left side plate (32), large pulley (29),
belt (28) and left side cover (31).
29
32
28

11.4 STORE THE MACHINE

• Clean the machine before storage.
• Make sure the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose
or damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person at an approved service
center.
• Store the machine in a dry area.
English
24
27 31
33
26
• Make sure that children cannot come near the
machine.
12

TROUBLESHOOTING

Problem Possible cause
The handle is The bolts are not
not in position. engaged correct-
ly.
The machine The battery is
does not start. not charged.
The switch is de-
fective.
Battery is too
cold.
Battery may re-
quire service or
replacement.
The engine is The belt is dam-
on, but the im- aged.
peller does not
turn.
A thin layer of The scraper is
snow stays be- damaged.
hind.
* If you cannot find the solution to these problems, call
1-888-909-6757.
13

TECHNICAL DATA

Voltage
No load speed
13
Solution
Adjust the height
of the handle
and make sure
that the knobs
and bolts are
aligned correctly.
Charge the bat-
tery by following
the procedures
in the battery
and charger
manual.
Have the switch
replaced by an
authorized serv-
ice center.
Remove battery
from snow throw-
er. Place battery
on charger and
allow to charge
for 10 minutes or
until the chang-
ing light turns
green. Remove
from charger and
install in snow
thrower for use.
Call toll free
helpline, at
1-888-909-6757
or replace bat-
tery.
Replace the belt.
Replace the
scraper.
40 V
1900 ± 10% / min
EN