Operation Tips; Replace The Impeller; General Maintenance; Replace The Scraper - GreenWorks SNA107 Manual Del Operador

7.7

OPERATION TIPS

• If it is possible, clear the snow with the direction of the
wind.
• In strong winds, lower the chute deflector to direct the
snow to the ground.
• When you complete the work, let the machine operate for
a while to prevent ice formation in the discharge chute.
• If the snow is deeper than 8", decrease the speed and let
the machine work at its own rhythm.
• Do not use the scraper to remove compact snow and ice.
8 MAINTENANCE
WARNING
Disconnect the extension cord before maintenance.
CAUTION
Use only approved replacement parts.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
8.1

GENERAL MAINTENANCE

• Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
• Tighten all the fasteners and caps correctly.
• Clean the remaining snow on the machine with a brush.
8.2

REPLACE THE SCRAPER

24
24
English
Use only approved replacement scrapers.
Wear heavy gloves or wind cloth around the impeller when
you touch the impeller.
1. Remove the screws (24) from each side plate.
2. Remove and discard the old scraper.
3. Install the new scraper.
4. Put in the mounting screw (25) and spacers and tighten
8.3
Use only approved replacement scrapers.
1. Remove the 5 screws (24) and side wear pad (26) that
2. Remove the nut (27).
25
11
WARNING
WARNING
them.

REPLACE THE IMPELLER

WARNING
secure the right side cover (31).
EN