Cleaning Instructions - Weston 07-3201-W-A Manual De Instrucciones

WARNING!
Before cleaning, assembling or disassembling the grinder,
make sure the PLUG IS REMOVED FROM THE OUTLET/POWER SOURCE!
ALWAYS unplug the grinder when not in use.

CLEANING INSTRUCTIONS

NOTE: It is IMPORTANT TO FOLLOW ALL of the
manufacturers instructions for the grinder that will be used.
Failure to do so may cause injury!
1. Thoroughly wash all parts in soapy water. Rinse with
clean water. Dry all parts immediately. NOTE: DO NOT
immerse the Blade Assembly in sudsy water where
they cannot be seen. To prevent injury, keep the Blade
Assembly visible at all times. CAUTION: The Blades
are very sharp!
2. Coat all metal parts with a food grade silicone spray.
HELPFUL HINT: A long, skinny brush is helpful when cleaning the Blade Assembly.
ASSEMBLY INSTRUCTIONS
1. Install the Chute to the Top Housing
using an Allen Wrench and the 2 Chute
Screws and Lock Washers (Figure A).
2. Insert the Blade Assembly into the
Lower Housing, guiding the Drive Shaft
into the journals. Make sure the gears
and the blades of the Blade Assembly
are properly meshed together and resting
in the journals (Figure B). NOTE: The
Tenderizer Blade is a 2-piece set. The
Jerky Slicer Blade is a single piece
.
separately)
3. Using the Allen Wrench/Blades &
Shaft Adapter, tighten the Shaft Adapter
Set Screw to secure the Shaft Adapter to
the Drive Shaft.
Chute
Top
Housing
Allen
(sold
Wrench
Top
Housing
Journals
Lower
Housing
-5-
Figure A
Chute Screws
(2) & Lock
Washers (2)
Figure B
Allen
Wrench
Blade
Assembly
Drive Shaft
Shaft
Adapter
Journals