Weston 07-3201-W-A Manual De Instrucciones página 7

WARNING!
Before cleaning, assembling or disassembling the grinder,
make sure the PLUG IS REMOVED FROM THE OUTLET/POWER SOURCE!
ALWAYS unplug the grinder when not in use.
ATTACHING TO THE GRINDER
NOTE: It is IMPORTANT TO FOLLOW ALL of the manufacturers instructions for the grinder
that will be used. Failure to do so may cause injury!
1. Unscrew the head locking knob of the electric grinder until the end of the threads
are no longer protruding into the grinder output housing.
2. Line up the grinder pin with the Shaft Adapter notch on the electric grinder. Line
up the Shaft Adapter splines with the grinder output housing (Figure D).
NOTE: You may have to reposition the Cuber/Tenderizer Shaft splines so that
they match up with the grinder output shaft. Make sure the grinder head locking knob
lines up with the groove in the side of the electric grinder adapter.
3. Once the Cuber/Tenderizer Attachment is properly positioned on to the electric
grinder, tighten the grinder head locking knob (Figure E).
Shaft Adapter
Notch
Shaft Adapter
Splines
Grinder
Pin
Output Shaft
Splines
-7-
Figure D
Head Locking
Knob of Grinder
Figure E