Saber R33CC0312 Instrucciones De Montaje página 11

Ocultar thumbs Ver también para R33CC0312:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Procedure - Replacing your Side Burner - New Side Burner Installation
You will now reinstall the Bezels and Control Knobs.
8
Your Side Burner may have only one Control Knob. If your
Side Burner has TWO Control Knobs, be sure to complete
each Bezel and Knob before moving to the next one. This
will keep the Manifold properly attached to the rear of the
Control Panel.
Using a Phillips Screwdriver, remove the two #8 machine
Screws and Washers (if provided) from the Control Panel.
Position the Bezel on the Side Burner with the Valve stem
in the center of the Bezel, as shown at right.
Reinstall the Screws and Washers (if provided).
Align the Control Knob to the Valve Shaft and firmly press
into place.
Repeat this step for the remaining Control Knob, if
equipped.
Orient the Control Knob to align the D-shaped stem to the
opening in the Knob and press it on until the Knob is just
inside the Bezel. Repeat these steps for each of the
Valves to install the Knobs.
CAUTION: Do not rotate the Knobs clockwise past the
OFF   position to avoid damage to the Valves.
Pack the Side Burner and the Control Panel into each original carton provided with your new parts. Pack both cartons into the
original outer shipping carton provided. Apply the return shipping label provided to the orignial outer shipping carton for return
shipment back to Saber Grills.
Congratulations! You are now finished with the replacement of parts on your Saber Grill. You will need to perform a thorough
leak check procedure on your Grill to ensure there are no gas leaks.
Procedure - Performing the Leak Check
1
Gloves will not be needed now.
Ÿ
The next step will be to reinstall your LP Cylinder,
Ÿ
connect the Hose and Regulator to the LP Cylinder,
and leak check your new connection.
Do not install the grease tray at this point.
Ÿ
First, you will need a Cup or a small Bucket, a small
Ÿ
soft Bristle Brush (such as a Paint Brush), and
dishwashing liquid.
Next, create a 50/50 soapy solution of water and
Ÿ
dishwashing liquid.
© Saber Grills, LLC
All manuals and user guides at all-guides.com
11
Proper Bezel-to-Valve
Stem Alignment
80028080 ● 09/13/17 ● Revision 03
Printed in U.S.A.
sabergrills.com

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

R33sc0012R50cc0312R50cc0612R50sc0012R50c1715R67sc0012

Tabla de contenido